|Published (Last):||24 September 2019|
|PDF File Size:||8.97 Mb|
|ePub File Size:||18.23 Mb|
|Price:||Free* [*Free Regsitration Required]|
Page Parameters If one of the standard ramp modes is selected see Pr 30 on page 31 , the deceleration NOTE rate could be extended automatically by the drive to prevent over voltage OV trips if the load inertia is too high for the programmed deceleration rate. Page 23 Voltage input and 3 preset speeds AI.
Pr Current input and 3 preset speeds 4 preset speeds Keypad control E. Page 27 Level 3 access - All parameters from 01 to 95 can be accessed LoC: Used to lock a security code in the drive. See section 5. Page Parameter Descriptions - Level 2 The output not programmed to the brake control can be programmed to indicate the required signal. Page 29 Multiplying factor on motor speed rpm to give customer defined units.
Page 30 The drive must be in a disabled, stopped or tripped condition to allow default parameters NOTE to be set. If default parameters are set while the drive is running, the display will flash FAIL once before changing back to no.
Page 31 Fr, Fr. Page 33 Not selecting another mode could result in poor motor performance or OI. AC, It. AC or OV trips. Page 34 The ramp is held during this time. Function Range Defaults Type Post brake release delay 0. Any out-of-range parameter writes attempted will cause the drive to trip. Function Range Pr 61 to Pr 70 can then be adjusted to change the value within a parameter. Diagnostic parameters The following read only RO parameters can be used as an aid to fault diagnosis on the drive.
Ld1 trip. Table DC bus voltages Drive voltage rating The fan will then switch on and run at full speed for a minimum of 20s.
Leroy Somer DIGIDRIVE SK Manuals
DigiDrive SK Series
Leroy Somer DIGIDRIVE SK Getting Started Manual